Ebode EWD18 Podręcznik Użytkownika Pobierz pdf (Strona 3)

7-5-2013 3 ebode eWD18

2. Introduction

Thank you for purchasing the ebode eWD18. Get warned by flooding and intervene to

prevent against water damage. The ebode water detector is battery operated and provided

with 2 sensors which have to be placed on the location where water will be expected. When

detecting water or moisture the eWD18 will sound an alarm (85DB), like a smoke detector

does as a stand-alone system. To register the eWD18 to an X-10 network (BS800

HomeGuard and ProtectorPlus BS880/4 and BS880/7), the water detector is part of your

X10 security system and here an alarm message will also be given.

For more information please see HomeGuard and ProtectorPlus guides.

The eWD18 can operate with the following security consoles:

 SC28 Home Protector

 BS800 HomeGuard

 The eWD18 can also operate as stand-alone unit without console.

3. Specifications

Operating voltage: 3VDC (2 x “AAA”size battery)

RF Frequency: 433.92MHz ± 150KHz

RF Operation range: 100M open field, up to 30M through wall and ceiling

Operating Temperature: 0℃ - +40℃

Storage Temperature: -20℃ - +70℃

Battery life: over 1 year (standby mode)

X10 command support: Standard X10 RF security command (Panic & disarm)

Sound pressure level: 80dB min at 4KHz / 6V / 10cm

4. Installation Instructions

1. Transmitter part – Built-in antenna.

2. Control indicator LED – When pressing the “Register” button (4), or when the unit is

transmitting a signal to the base station, this LED will light up. When the LED blinks weakly,

batteries have to be replaced.

3. Screw holes for mounting the sensor.

4. Button to register the water detector to the SC28 and BS800 Security Console.

5. Battery compartment.

6. Connection for water sensor.

Figure 1.1

1 2 3 4 5 6 7 8 ... 31 32

Brak uwag

Ebode EWD18 Podręcznik Użytkownika Strona 3